Analogue Shore hardness tester. Sauter HB. Shore A.

Available in several variants

Brand:

• Typical application: measurement of penetration (Shore)
• Particularly recommended for internal comparison measurement. Standard calibrations e. g. to DIN 7619-1 are often not possible because of very narrow standard tolerances
• Shore A rubber, elastomers, neoprene, silicone, vinyl, soft plastics, felt, leather and similar material
• Shore D plastics, formica, epoxides, plexiglass etc.
• Shore A0 foam, sponge etc.
• Max mode: Holds the maximum value in the display
• Point mode: Shows one instant value
• Can be attached to the test stands SAUTER TI-A0 (for Shore A and A0), TI-D. (for Shore D)
• Delivery in a plastic box
• Measuring range (Max): 100 HA
• Readout (d): 1,0 HA

Hardness comparison plates see AHBA-01 and AHBD-01